Previous Topic Next Topic

Can't boot with IDE primary master and primary slave hard drives

Closed
norma60 Posts 2 Registration date Thursday January 15, 2015 Status Member Last seen January 15, 2015 - Jan 15, 2015 at 02:47 PM
BrianGreen Posts 1005 Registration date Saturday January 17, 2015 Status Moderator Last seen September 30, 2021 - Jan 17, 2015 at 05:13 PM
Hello
I would if you could give me some advice . my computer is saying I have no Can't boot with IDE primary master and primary slave hard drives ,I went into bios they was switched off. how do I put them on . my computer is in a loop switches on say restart normal windows .I press return and it restarts again .
Please Help I would be very greatful
Related:

1 response

Answer 1 / 1
BrianGreen Posts 1005 Registration date Saturday January 17, 2015 Status Moderator Last seen September 30, 2021 149
Jan 17, 2015 at 05:13 PM
Have you recently added the new hard drive? iIf so is it on the same line as another IDE device? Have you set the jumper on the drive to make it a slave drive? The jumper is normally a little shorting thing (usually looking like a bit of black, blue, or red plastic about 1mm by 2mm and when in place is among by a double row of pins - next to where you plug the IDE cable into).
0

Similar discussions

No HDD detected in Lenovo
Pochu.vinay -
R2D2_WD -

1 response
StoreJet Transcend Hard Drive cant be found in My Computer
Mariela -
joby -

6 responses
How do I change a base location on Instagram?
rebelkids -
38nancy -

8 responses