Tx1000 motherboard changed but still blank screen

Closed
Benla_18 Posts 2 Registration date Monday September 2, 2013 Status Member Last seen September 3, 2013 - Sep 2, 2013 at 08:32 PM
Benla_18 Posts 2 Registration date Monday September 2, 2013 Status Member Last seen September 3, 2013 - Sep 3, 2013 at 03:11 PM
I Have been given a tx1000 that had a blank screen, the fan came on as did the lights but nothing on the screen, so I replaced the motherboard but still have the same problem.
Any ideas, solutions, tips or tricks would be much appreciated
Thanks
Ben

2 replies

carminabigue Posts 620 Registration date Tuesday March 19, 2013 Status Member Last seen June 10, 2015 145
Sep 3, 2013 at 11:40 AM
Try the over heat solution with a hair dryer heated up the Corner of the unit where the fan is. Being careful not to get the surface of the plastic too hot. i keep turning the unit on and off and about two minutes in the laptop turned on just fine.

If you not believe here the link from the thread :https://ccm.net/forum/affich-56849-hp-tx1000-boots-a-blank-screen
0
Benla_18 Posts 2 Registration date Monday September 2, 2013 Status Member Last seen September 3, 2013
Sep 3, 2013 at 03:11 PM
Thanks for the answer, I tried the hair dryer trick but the pc over heated in less than a minut and shut down, tryed it a few times but still nothing.
0