HP Designjet 130nr always prints 3 pages aligning printhead test
Closed
keff2014
Posts
2
Registration date
Saturday May 31, 2014
Status
Member
Last seen
May 31, 2014
-
May 31, 2014 at 03:03 PM
carminabigue Posts 620 Registration date Tuesday March 19, 2013 Status Member Last seen June 10, 2015 - Jun 1, 2014 at 11:24 PM
carminabigue Posts 620 Registration date Tuesday March 19, 2013 Status Member Last seen June 10, 2015 - Jun 1, 2014 at 11:24 PM
1 response
carminabigue
Posts
620
Registration date
Tuesday March 19, 2013
Status
Member
Last seen
June 10, 2015
125
Jun 1, 2014 at 11:24 PM
Jun 1, 2014 at 11:24 PM
Hi,
If you will notice on the sheets that print that there will be an X in the right side. Usually the color that has the X is the printhead that is bad and needs replacing before it will have a good alignment. I just recommend looking at the little blocks to see which ones are bad with lines thru them or just plain missing blocks and replace those printheads. When the alignment is successful you will have a check mark on the right side. If the prints are ok then the only things you can do is leave the plotter on all the time or when the first sheet starts to print on power on hit the cancel button and it will eject the first sheet and will allow printing.
Good Luck!
If you will notice on the sheets that print that there will be an X in the right side. Usually the color that has the X is the printhead that is bad and needs replacing before it will have a good alignment. I just recommend looking at the little blocks to see which ones are bad with lines thru them or just plain missing blocks and replace those printheads. When the alignment is successful you will have a check mark on the right side. If the prints are ok then the only things you can do is leave the plotter on all the time or when the first sheet starts to print on power on hit the cancel button and it will eject the first sheet and will allow printing.
Good Luck!
