Pen drive unable to complete format.
Closed
carzola
Posts
1
Registration date
Sunday December 20, 2015
Status
Member
Last seen
December 20, 2015
-
Dec 20, 2015 at 01:11 AM
R2D2_WD Posts 3606 Registration date Monday September 1, 2014 Status Member Last seen February 20, 2017 - Dec 21, 2015 at 04:59 AM
R2D2_WD Posts 3606 Registration date Monday September 1, 2014 Status Member Last seen February 20, 2017 - Dec 21, 2015 at 04:59 AM
Related:
- Pen drive unable to complete format.
- Wd drive unlock - Guide
- How to remove write protection from pen drive - Guide
- Unable to ping computer on same network - Guide
- Pen drive ✓ - Pen Drive, USB & SD Card Forum
- Could not complete this operation. there was not enough memory available - Guide
1 response
R2D2_WD
Posts
3606
Registration date
Monday September 1, 2014
Status
Member
Last seen
February 20, 2017
155
Dec 21, 2015 at 04:59 AM
Dec 21, 2015 at 04:59 AM
Hi carzola,
Are you trying to format using the Disk Management? Could you check if the pen drive appears with the correct format or it has changed to RAW? I strongly recommend you to try the pen drive on another PC in order to confirm where the issue is coming from. Try using the diskpart command from the Command prompt. It should be like this:
Diskpart
List disk
Select disk n (where n should be the number of the drive)
Clean
Create partition primary
active
format fs=ntfs label=”Flash” quick
assign
http://www.doztech.net/howto/format-your-flash-drive-with-diskpart/ - check the article for more detailed information.
Hope this helps
Are you trying to format using the Disk Management? Could you check if the pen drive appears with the correct format or it has changed to RAW? I strongly recommend you to try the pen drive on another PC in order to confirm where the issue is coming from. Try using the diskpart command from the Command prompt. It should be like this:
Diskpart
List disk
Select disk n (where n should be the number of the drive)
Clean
Create partition primary
active
format fs=ntfs label=”Flash” quick
assign
http://www.doztech.net/howto/format-your-flash-drive-with-diskpart/ - check the article for more detailed information.
Hope this helps
