Starting problem

[Closed]
Report
Posts
8
Registration date
Tuesday April 25, 2017
Status
Member
Last seen
May 12, 2017
-
Posts
8
Registration date
Tuesday April 25, 2017
Status
Member
Last seen
May 12, 2017
-
3weeks ago i have install windows 10 transformation pack 7.0 on my Windows xp desktop and it was worked fine but yesterday i configured a little and than every time i play hd videos my CRT monitor shows frequency out of range and evrything turn of except cpu fan hard drive and power switch than i disconnect main power wire and it three times and i disconnect the power wire and now when i press power button only the cpu fan power switch and hard drive what should i do now.

1 reply


SO, the OS is XP?

I am confused by the following statement, please clarify:

"now when i press power button only the cpu fan power switch and hard drive what should i do now."

I have never seen a power switch on a harddrive.
> Blocked Profile
Yes xp. Please tell me what to do.
Blocked Profile
boot it into safe mode, and uninstall what you installed. VIOLA that is it!
Posts
8
Registration date
Tuesday April 25, 2017
Status
Member
Last seen
May 12, 2017
1 > Blocked Profile
Nothing on screen and no power on key board. so how i boot into safe mode
Blocked Profile
Well if it doesn't boot, then it doen't boot. You should be able to hit F8 to get into a screen that will allow you to select safe mode.
Posts
8
Registration date
Tuesday April 25, 2017
Status
Member
Last seen
May 12, 2017
1 > Blocked Profile
no power on key board so how F8 going to work. And i think that's not the problem with the what I'm install. this can be problem of "ram, motherboard , cpu, power supply" what you think please replay.