Can anyone recover DWG files?

Solved/Closed
magnusjohannesson3 Posts 2 Registration date Sunday February 15, 2015 Status Member Last seen February 17, 2015 - Feb 15, 2015 at 07:46 AM
magnusjohannesson3 Posts 2 Registration date Sunday February 15, 2015 Status Member Last seen February 17, 2015 - Feb 17, 2015 at 05:30 AM
Hello,
Can anyone recover DWG files? I open the file through AutoCad 2011, and writes "the file of the drawing is damaged"! Who can restore if the .bak file isn't available? Only .dwg! sad. Through the recovery Manager in general it is impossible. The file was created in AutoCad 2007.


2 replies

johnstewart497 Posts 2 Registration date Monday February 16, 2015 Status Member Last seen February 17, 2015 2
Feb 16, 2015 at 10:45 AM
To insert the file as the link or the block.
It is possible to try to insert into the new file "damaged" as the external link or the block.
To insert a file as an external reference:
  • on the menu bar, go to Insert - the Link to DWG and to choose the necessary file;
  • enter the command _.xref and select the desired file.

To insert a file as a block:
  • on the menu bar, go to Insert - Block and choose the file;
  • enter the command _.insert and select the desired file.
2
johnstewart497 Posts 2 Registration date Monday February 16, 2015 Status Member Last seen February 17, 2015 2
Feb 17, 2015 at 05:29 AM
0
magnusjohannesson3 Posts 2 Registration date Sunday February 15, 2015 Status Member Last seen February 17, 2015 > johnstewart497 Posts 2 Registration date Monday February 16, 2015 Status Member Last seen February 17, 2015
Feb 17, 2015 at 05:30 AM
Thank you! very helpful advice in this article!
0
Ambucias Posts 47357 Registration date Monday February 1, 2010 Status Moderator Last seen September 1, 2021 11,234
Feb 15, 2015 at 04:30 PM
You files are corrupted, hence they cannot be recovered.

Sorry
0