Failed to get display in the monitor
Closed
Juan
-
Mar 31, 2011 at 08:38 AM
jack4rall Posts 6428 Registration date Sunday June 6, 2010 Status Moderator Last seen July 16, 2020 - Mar 31, 2011 at 10:57 AM
jack4rall Posts 6428 Registration date Sunday June 6, 2010 Status Moderator Last seen July 16, 2020 - Mar 31, 2011 at 10:57 AM
Hello, Can you please guide me in some directions? When I press the on button, my computer power light comes on, the fan inside runs, but the monitor light turns green for a half a second then back to yellow. I know that it's not receiving a signal, nor does the computer boot up. This all started after cleaning the dust out and repairing the blade on the fan. I did remove the heat sink under the fan. Could this have caused the problem that I'm experincing and how do I fix it? Please help?
Related:
- Failed to get display in the monitor
- Computer turns on but no display on monitor - Guide
- Huawei display check code - Guide
- To display a text file in reverse order what command should be used - Guide
- Monitor power light blinking but no display reasons - CPU & Desktop Forum
- Can cmos battery cause no display ✓ - Motherboard Forum
1 response
jack4rall
Posts
6428
Registration date
Sunday June 6, 2010
Status
Moderator
Last seen
July 16, 2020
Mar 31, 2011 at 10:57 AM
Mar 31, 2011 at 10:57 AM
Hello,
Try this 1
Remove the RAM from the slot, clean it and place it back properly or try another
slot.
Now Switch ON your computer.
If you are using a graphic card, then remove it and place it back properly.
Note : You need to apply a new thermal compound if CPU FAN is removed.
Remove the old thermal compound from the processor and heat sink.
You need to be careful when removing the old thermal compound from the
processor.
Now freshly apply some thermal compound in the middle of processor and
fix the CPU FAN properly.
Good Luck
Try this 1
Remove the RAM from the slot, clean it and place it back properly or try another
slot.
Now Switch ON your computer.
If you are using a graphic card, then remove it and place it back properly.
Note : You need to apply a new thermal compound if CPU FAN is removed.
Remove the old thermal compound from the processor and heat sink.
You need to be careful when removing the old thermal compound from the
processor.
Now freshly apply some thermal compound in the middle of processor and
fix the CPU FAN properly.
Good Luck
