Related:
- To create a network bridge you must select at least two lan
- Lan settings - Guide
- Windows network commands - Guide
- Network error occurred - Guide
- What is a network card - Guide
- Vba select case like - Guide
1 response
jack4rall
Posts
6428
Registration date
Sunday 6 June 2010
Status
Moderator
Last seen
16 July 2020
30 Jun 2012 à 14:08
30 Jun 2012 à 14:08
Hello,
Try this 1
Go to the "Security" Tab in the sharing options. In "Group or user names:"
--> Click on "Add" --> In "Enter the object names to select", type Everyone
and click on "Check Names", then click on OK --> Then in "Permissions" section -->
Select your required permissions and click on OK.
Good Luck
Try this 1
Go to the "Security" Tab in the sharing options. In "Group or user names:"
--> Click on "Add" --> In "Enter the object names to select", type Everyone
and click on "Check Names", then click on OK --> Then in "Permissions" section -->
Select your required permissions and click on OK.
Good Luck
30 Jun 2012 à 22:58
.I forget to mention in my post..
After that too , the same problem prevails