Hard disk not detect
Closed
Dinesh
-
Apr 13, 2013 at 08:19 AM
jack4rall Posts 6428 Registration date Sunday June 6, 2010 Status Moderator Last seen July 16, 2020 - Apr 13, 2013 at 04:51 PM
jack4rall Posts 6428 Registration date Sunday June 6, 2010 Status Moderator Last seen July 16, 2020 - Apr 13, 2013 at 04:51 PM
Hello, Hello,
If i tried to install windows 7 i am getting following error.
Setup did not find any hard disk drives installed in your computer.
Make sure any hard disk drives are powered on and properly connected to your computer, and that any disk-related hardware configuration is correct. This may involve running a manufacturer - supplied diagnostic or setup program.
Setup cannot continue. To quit Setup, press F3
pls advice what i should do?
If i tried to install windows 7 i am getting following error.
Setup did not find any hard disk drives installed in your computer.
Make sure any hard disk drives are powered on and properly connected to your computer, and that any disk-related hardware configuration is correct. This may involve running a manufacturer - supplied diagnostic or setup program.
Setup cannot continue. To quit Setup, press F3
pls advice what i should do?
Related:
- Hard disk not detect
- Blackmagic disk speed test windows - Download - Diagnosis and monitoring
- Simple diagram of hard disk - Guide
- Hard disk regenerator - Download - Backup and recovery
- Floppy disk fail 40 - Guide
- Nvidia drivers auto detect - Guide
1 response
jack4rall
Posts
6428
Registration date
Sunday June 6, 2010
Status
Moderator
Last seen
July 16, 2020
Apr 13, 2013 at 04:51 PM
Apr 13, 2013 at 04:51 PM
Hello,
Try this 1
1) First check all your connections to your "Hard drive".
2) Make sure that your hard drive is detected in CMOS. Go to CMOS settings,
select the option "Load default settings" --> Check if your hard drive is detected
or not --> Save the settings and exit from it.
Good Luck
Try this 1
1) First check all your connections to your "Hard drive".
2) Make sure that your hard drive is detected in CMOS. Go to CMOS settings,
select the option "Load default settings" --> Check if your hard drive is detected
or not --> Save the settings and exit from it.
Good Luck
