Previous Topic Next Topic

Monitor not getting signal on pc startup,tried multiple fixes :(

Closed
vicwiz007 Posts 7 Registration date Friday April 3, 2015 Status Member Last seen April 4, 2015 - Apr 3, 2015 at 10:36 AM
 vicwiz007 - Apr 14, 2015 at 06:49 PM
My over seems to start up normally when I hit the power button, but the monitor does not receive Any signal at all, and not sure if this matters but the keyboard turns on for a second but then off and stays off, and the mouse goes on nor.ally and stays on. I have tried unplugging stuff, unplugging the power cord to over and holding power for 30 seconds, and even reseated the 2 ram chips in it but nothing worked :(

Please help and thanks in advance!
Related:

1 response

Answer 1 / 1
xpcman Posts 19530 Registration date Wednesday October 8, 2008 Status Contributor Last seen June 15, 2019 1,825
Apr 3, 2015 at 01:35 PM
perhaps this FAQ can help:

https://ccm.net/faq/10370-monitor-shows-no-signal-after-cpu-starts

Good Luck
0
vicwiz007 Posts 7 Registration date Friday April 3, 2015 Status Member Last seen April 4, 2015
Apr 3, 2015 at 01:49 PM
Before I try to do all the stuff in the solution, does it make a difference that in his case the monitor goes o and says no signal but mine just doesn't change at all from it's orange light hibernation state
0
xpcman Posts 19530 Registration date Wednesday October 8, 2008 Status Contributor Last seen June 15, 2019 1,825 > vicwiz007 Posts 7 Registration date Friday April 3, 2015 Status Member Last seen April 4, 2015
Apr 3, 2015 at 02:24 PM
I wouldn't bother with the steps from the FAQ.
Did you try using only one of the memory modules at a time? You might have a BAD module.
You might have a bad power supply or motherboard. It's all guess work without "hands on" access to the computer.
0
vicwiz007 Posts 7 Registration date Friday April 3, 2015 Status Member Last seen April 4, 2015 > xpcman Posts 19530 Registration date Wednesday October 8, 2008 Status Contributor Last seen June 15, 2019
Apr 3, 2015 at 02:37 PM
So I tried each ram, no luck getting a signal with either, then I put both back in and turned it on and got 6 beeps and an orange light on the over. Not gonna do anything until someone tells me so I do t mess anything up
0
xpcman Posts 19530 Registration date Wednesday October 8, 2008 Status Contributor Last seen June 15, 2019 1,825 > vicwiz007 Posts 7 Registration date Friday April 3, 2015 Status Member Last seen April 4, 2015
Apr 3, 2015 at 05:54 PM
Is this a desktop or laptop computer?

for an AMI BIOS I find two explanations

6 Beeps
Six beeps means that there has been an 8042 Gate A20 test error. This beep code is usually caused by an expansion card that has failed or a motherboard that is no longer working.
6 short beeps
Keyboard controller Gate A20 error: The keyboard controller has failed. Due to its integration into the system board, you usually must replace the motherboard.
0
vicwiz007 Posts 7 Registration date Friday April 3, 2015 Status Member Last seen April 4, 2015
Apr 3, 2015 at 06:30 PM
Itsa desktop so what my pc need to be replaced basically or motherboard or whatever.
0