Pen drive showing empty when data exists
Closed
akki123321
Posts
1
Registration date
Tuesday April 18, 2017
Status
Member
Last seen
April 18, 2017
-
Updated on Apr 18, 2017 at 05:30 PM
Promomilia Posts 68 Registration date Monday February 6, 2017 Status Contributor Last seen May 19, 2017 - Apr 21, 2017 at 12:50 AM
Promomilia Posts 68 Registration date Monday February 6, 2017 Status Contributor Last seen May 19, 2017 - Apr 21, 2017 at 12:50 AM
Related:
- Pen drive showing empty when data exists
- Wd drive unlock - Guide
- How to remove write protection from pen drive - Guide
- Flash drive/card tester - Download - Backup and recovery
- Tmobile data check - Guide
- Ps3 disc drive not working - Guide
1 response
Promomilia
Posts
68
Registration date
Monday February 6, 2017
Status
Contributor
Last seen
May 19, 2017
12
Apr 21, 2017 at 12:50 AM
Apr 21, 2017 at 12:50 AM
Hey
Just try these steps , may be it will help :
First Method : Check if the files are not hidden.
If files are not hidden then use the Second Method.
Goto Start –> Run –> Type cmd & Press Enter. Now Command Prompt will open.
Here I assume your Pen Drive drive letter as I:
Now Enter the below command :
attrib -h -r -s /s /d i:\*.*
Replace “i” with your pen-drive letter
Or else
http://www.tangosoft.co.uk/
-- insert card into memory slot
-- navigate to folder where software was downloaded
-- double click on Re-enable.exe file
-- enter password if needed
-- once program opens, click on tools
-- select scan and delete Auturun.inf
-- once that is completed, click on tools again
-- click on reset files/ folder attributes
Just try these steps , may be it will help :
First Method : Check if the files are not hidden.
If files are not hidden then use the Second Method.
Goto Start –> Run –> Type cmd & Press Enter. Now Command Prompt will open.
Here I assume your Pen Drive drive letter as I:
Now Enter the below command :
attrib -h -r -s /s /d i:\*.*
Replace “i” with your pen-drive letter
Or else
http://www.tangosoft.co.uk/
-- insert card into memory slot
-- navigate to folder where software was downloaded
-- double click on Re-enable.exe file
-- enter password if needed
-- once program opens, click on tools
-- select scan and delete Auturun.inf
-- once that is completed, click on tools again
-- click on reset files/ folder attributes
