Satellite A300. Reseting to factory setting [Solved/Closed]
Tan - - Latest reply: naughty - Jan 15, 2015 at 08:11 AM
Related:
- Toshiba satellite a300 recovery
- Toshiba a300 bios password reset - Best answers
- Toshiba satellite a300 bios password reset - Best answers
- Toshiba satellite a300 bios password reset ✓ - Forum - BIOS
- Toshiba satellite c55 recovery disk download ✓ - Forum - Recovery software
- Toshiba satellite c850 recovery disk download ✓ - Forum - Recovery software
- Reset Toshiba laptop to factory settings ✓ - Forum - Laptop
- Toshiba satellite c655 recovery ✓ - Forum - Windows 7
1 reply
Best answer
Greatings,
Follow these instructions:
* 1) Hold down the power button for 10 (ten) seconds to switch off your machine.
Please note: Holding down the power button on the machine forces it to switch off. Any unsaved data will be lost.
* 2) Press and hold the 0 (zero) key and at the same time, tap the power button once to switch on your notebook.
* 3) When the machine Starts beeping; release the 0 key.
* 4) When prompted by the warning screen; select Yes to continue with the system recovery.
* 5) Select Recovery of Factory Default Software; click Next.
* 6) Select Recover to out-of-box state. Click Next again.
* 7) Click Next to Start recovery.
PS:ALL DATA WILL BE ERASED ON YOUR HARD DRIVE IF YOU PROCEED. YOU WILL NEED TO ENSURE THAT YOU HAVE THE POWER ADAPTER PLUGGED IN. DO NOT SWITCH OFF OR RESTART YOUR COMPUTER DURING THIS PROCESS.
Regards!
Follow these instructions:
* 1) Hold down the power button for 10 (ten) seconds to switch off your machine.
Please note: Holding down the power button on the machine forces it to switch off. Any unsaved data will be lost.
* 2) Press and hold the 0 (zero) key and at the same time, tap the power button once to switch on your notebook.
* 3) When the machine Starts beeping; release the 0 key.
* 4) When prompted by the warning screen; select Yes to continue with the system recovery.
* 5) Select Recovery of Factory Default Software; click Next.
* 6) Select Recover to out-of-box state. Click Next again.
* 7) Click Next to Start recovery.
PS:ALL DATA WILL BE ERASED ON YOUR HARD DRIVE IF YOU PROCEED. YOU WILL NEED TO ENSURE THAT YOU HAVE THE POWER ADAPTER PLUGGED IN. DO NOT SWITCH OFF OR RESTART YOUR COMPUTER DURING THIS PROCESS.
Regards!
A few words of thanks would be greatly appreciated. Add comment
4331 users have said thank you to us this month
- Posts
- 1
- Registration date
- Monday November 3, 2014
- Last seen
- November 3, 2014
-That all went well until the recovery status bar was about 70% and then it stops and I get the message base.iso file is missing. Any ideas appreciated.