Want to make my pen drive as a bootable device
Closed
rajat41195
Posts
1
Registration date
Saturday May 23, 2015
Status
Member
Last seen
May 23, 2015
-
May 23, 2015 at 07:53 AM
KY_WD Posts 2053 Registration date Thursday October 23, 2014 Status Member Last seen February 28, 2017 - May 29, 2015 at 05:29 AM
KY_WD Posts 2053 Registration date Thursday October 23, 2014 Status Member Last seen February 28, 2017 - May 29, 2015 at 05:29 AM
Related:
- Want to make my pen drive as a bootable device
- Wd drive unlock - Guide
- How to remove write protection from pen drive - Guide
- How to install a second hard drive windows 11 - Guide
- Windows 7 bootable usb download - Download - Storage
- Synaptics pointing device driver - Guide
1 response
KY_WD
Posts
2053
Registration date
Thursday October 23, 2014
Status
Member
Last seen
February 28, 2017
122
May 29, 2015 at 05:29 AM
May 29, 2015 at 05:29 AM
Hello rajat41195,
According mentioned on the Microsoft's official web site, the steps are the following:
1. Insert a USB flash drive into a running computer.
2. Open a Command Prompt window as an administrator.
3. Type diskpart.
4. In the new command line window that opens, to determine the USB flash drive number or drive letter, at the command prompt, type list disk, and then click ENTER. The list disk command displays all the disks on the computer. Note the drive number or drive letter of the USB flash drive.
5. At the command prompt, type select disk <X>, where X is the drive number or drive letter of the USB flash drive, and then click ENTER.
6. Type clean, and the click ENTER. This command deletes all data from the USB flash drive.
7. To create a new primary partition on the USB flash drive, type create part pri, and then click ENTER.
8. To select the partition that you just created, type select part 1, and then click ENTER.
9. To format the partition, type format fs=ntfs quick, and then click ENTER.
Hope this helps.
KY_WD
According mentioned on the Microsoft's official web site, the steps are the following:
1. Insert a USB flash drive into a running computer.
2. Open a Command Prompt window as an administrator.
3. Type diskpart.
4. In the new command line window that opens, to determine the USB flash drive number or drive letter, at the command prompt, type list disk, and then click ENTER. The list disk command displays all the disks on the computer. Note the drive number or drive letter of the USB flash drive.
5. At the command prompt, type select disk <X>, where X is the drive number or drive letter of the USB flash drive, and then click ENTER.
6. Type clean, and the click ENTER. This command deletes all data from the USB flash drive.
7. To create a new primary partition on the USB flash drive, type create part pri, and then click ENTER.
8. To select the partition that you just created, type select part 1, and then click ENTER.
9. To format the partition, type format fs=ntfs quick, and then click ENTER.
Hope this helps.
KY_WD
