My laptop don't switch on

[Closed]
Report
Posts
1
Registration date
Friday April 12, 2013
Status
Member
Last seen
April 12, 2013
-
Posts
2368
Registration date
Sunday September 23, 2012
Status
Member
Last seen
December 13, 2018
-
Hi there my loptop doesn't switch on but if I connect the power suply the power light turns on for a few seconds then turns of if I press the power button nothing happens can anyone tell me what the problem can be please

3 replies

Posts
2368
Registration date
Sunday September 23, 2012
Status
Member
Last seen
December 13, 2018
43
Hi robbiekruger,

Please try the below mentioned steps and check if this works:

1. Power off the laptop.
2. Remove the battery and the AC Adapter.
3. Press and hold the power button for 5-10 seconds.
4. Release the power button.
5. Put the battery back and connect the AC adapter.
6. Try to power on the computer and check if there is any change.

You have mentioned in your post, "if I connect the power suply the power light turns on for a few seconds then turns of". I would like to know which power light you are referring to. Is it the light on the AC adapter or the power light on the laptop? Also, in your reply add the System Model Number of your laptop.

Please do write back to us.
Hi I have tried to remove the batery an the charger then hols the power button for a few minits but still nothing its a hp compaq nx 8220. When I plug in the charger think its the charging light (yellow green light) that comes on just for 5 seconds then it go off again but the laptop don't even start the fan its just dead.
Posts
2368
Registration date
Sunday September 23, 2012
Status
Member
Last seen
December 13, 2018
43
Hi robbiekruger,

Please follow the below mentioned steps in the specified order and check if this fixes the problem:

1. Try to power on the computer using only the AC Adapter (without the battery).
2. If there is no change, try to remove the following components in the order mentioned below:

a. Battery.
b. Hard Drive.
c. Optical Drive (CD/DVD drive).
d. External Memory Module.
e. Bluetooth Board.
f. Keyboard.

3. After removing the above components, reseat the "Switch Cover" cables.
4. With all these components removed and only the Switch Cover connected, power on the computer and check if you observe any difference.
5. If you hear any beeps or any sequence of LEDs (lights), start connecting the components one by one starting from (f.) to (a.) mentioned in step 2.
6. If you do not hear any beeps or any change in the indicators on the machine, this indicates some major component (such as Motherboard, Power sub system, etc.) is failing. You will need to contact HP support for further course of action.

(Note: These steps require you to reseat the components by removing the system cover/taking apart the chassis. Please perform these steps only if you are comfortable else seek a technician's help. Also, refer to the Service Manual for accurate steps and safety instructions. You can get the Service Manual by clicking here).

Do reply with results.

Thanks & Regards
Zohaib R
#iworkfordell