I got a problem about my pendrive

Closed
Tariq - Aug 27, 2015 at 04:31 AM
KY_WD Posts 2054 Registration date Thursday October 23, 2014 Status Member Last seen February 28, 2017 - Sep 10, 2015 at 03:53 AM
Hello,

Hello,
I got a problem about my pendrive.. i tried to format it and open it it ask me to insert a disk.. i Tried many solution from most of the forum but still dinn't work out.. any professional can giv me a better solution? My pendrive contain many important file and back up..
i will accept any help from all of you! please just make my pendrive work!
Please Help!

1 reply

KY_WD Posts 2054 Registration date Thursday October 23, 2014 Status Member Last seen February 28, 2017 120
Aug 28, 2015 at 09:29 AM
Hello Tariq,

Please, follow these steps:
1. Open command prompt
2. Type the following: attrib -s -h -r X: /*.* / s / d Then hit "Enter" and wait about 30 seconds Be careful! Respect the spaces between words and script. Change the letter X with that has been assigned to the SD card on your PC (that you can see it in My Computer. It can be anything, depends on each computer)
3. Finally, browse the flash drive and delete the "RECYCLER" folder and if there is another one called "Autorun" you have to delete that too. You could also try opening your SD card with data recovery software.

Good luck and come to share if that worked.
0
Bro, Showing * FILE IS NOT CORRECT. *
0
Bro, Showing__parameter format not correct.
0
KY_WD Posts 2054 Registration date Thursday October 23, 2014 Status Member Last seen February 28, 2017 120 > Tariq
Sep 10, 2015 at 03:53 AM
Hello again,

Make sure that you have full control over the folders so that you can change the attributes. In order to have it try the mentioned command when you start your PC in Save mode, meaning you have to open it as an administrator. If it doesn't work, then you could try the following options:
1. Right-click the flash disk shown in My Computer and select Properties> Click on the Security tab>Click Advanced in the lower right.
2. In the Advanced Security Settings window that pops up, and after that click on the Owner tab>Click Edit>Click Other users or groups>Click Advanced in the lower left corner>Click Find Now.
3. Scroll through the results and double-click on your current user account.
4. Click OK to all of the remaining windows except the first Properties window.
5. Select your user account from the list up top and click Edit.
6. Select your user account from the list up top again and then in the pane below, check Full control under Allow, or as much control as you need.
You'll get a security warning, click Yes.

Hope that I helped.
0