Lg 34wp500-b

Report
-
Posts
103
Registration date
Tuesday June 30, 2020
Status
Member
Last seen
May 19, 2021
-
Hello, so ive hooked up this new monitor to my tower and it turns on but only says no signal entering power saver mode shorty im using a d/p cable and also had tried using the vga / hdmi cord and neither one works


System Configuration: Windows / Chrome 90.0.4430.212

1 reply

Posts
103
Registration date
Tuesday June 30, 2020
Status
Member
Last seen
May 19, 2021
39
Monitors go into power saving when they do not see a data signal from the computer.

Check in Input Source menu to make sure it is looking at the right port. If it is, swap cables to look for a cable problem. If that doesn’t work, try a different port/cable connection (if you have choice between VGA, DVI, HDMI, DP at both ends). Borrow another laptop to test the computer end, and/or a different monitor/TV to test the TV end.

https://www.partitionwizard.com/partitionmagic/displayport-no-signal.html

If nothing makes the monitor work, then the monitor is probably bad. If the computer cannot drive anything, its video out is bad.

Subscribe To Our Newsletter!

The Best of CCM in Your Inbox

Subscribe To Our Newsletter!