Previous Topic Next Topic

Monitor no input signal after standby

Closed
Alex R - Oct 28, 2009 at 08:22 PM
 liz - Oct 23, 2010 at 07:55 PM
Hello,
I have a HP w2408h monitor. It's connected to my computer with a (new) HDMI-DVI cable. This works fine until the point the monitor goes standby. When I return to my computer it won't respond and it says no input signal. I tried turning off the power saver but the same problem reappears. Sometimes it'll work again by restarting but most of the time this doesn't work and I have to reconnect everything again and just hope it'll work again. Sometimes it does, sometimes it doesn't.
As you can imagine this is quite frustrating. Does anybody have an idea how to solve this? Would be greatly appreciated.

Alex
Related:

2 responses

Answer 1 / 2
liz
Oct 23, 2010 at 07:55 PM
no input signal, power saving device on
Answer 2 / 2
Blocked Profile
Oct 29, 2009 at 05:49 AM
Dear Alex,

Please check whether the 15 pin monitor cable and its power supply cable is not damaged.

This should be the source of the problem. Nevertheless do make sure that the graphic card

and motherboard is working properly.

Thanks in advance.

Similar discussions

Blue screen leading to "no signal" from monitor
i.p.mattingly -
ac3mark -

3 responses
Monitor says No Input signal Need help!
Nutiler -
pcsces -

2 responses
Forgotten input phone lock code
jared -
closeup22 -

1 response
LG monitor says D-sub no signal
Servant-Of-SSRR -
dinesh -

15 responses
No input signal
b\n -
xpcman -

1 response