Previous Topic Next Topic

Monitor doesn't recieve any signal from cpu.

Closed
deathwalker-pc Posts 2 Registration date Monday September 27, 2010 Status Member Last seen September 27, 2010 - Sep 27, 2010 at 12:50 PM
jack4rall Posts 6428 Registration date Sunday June 6, 2010 Status Moderator Last seen July 16, 2020 - Sep 27, 2010 at 01:13 PM
Hello,

my monitor doesn't get any signal from the cpu when its on.previously i used to change the sata port(since i have only one hard disk) from 0 to 1,2,3 and it would work most of the time.then it's gotten worse it doesn't work the first way and i tried installing the jumper in alternate mode and reinstalling it in the normal mode with changing the sata ports and it did work.Now it doesn't work either the first way nor the second. there is no problem with the hard disks nor the data cables(i've tried changing them)

any help would be very very very much appreciated.

1 response

Answer 1 / 1
jack4rall Posts 6428 Registration date Sunday June 6, 2010 Status Moderator Last seen July 16, 2020
Sep 27, 2010 at 12:53 PM
Hello,

Try this 1.

Remove the RAM from the slot, clean it and place it back properly or try another

slot. Check your RAM also, even bad RAM will result you in display problem.

If you are using graphic card, then remove it and place it back properly.

Good Luck.
1
deathwalker-pc Posts 2 Registration date Monday September 27, 2010 Status Member Last seen September 27, 2010
Sep 27, 2010 at 12:56 PM
i've tried both jack.:(
0
jack4rall Posts 6428 Registration date Sunday June 6, 2010 Status Moderator Last seen July 16, 2020
Sep 27, 2010 at 01:13 PM
Hello,
Remove all the Hard disk, CD\DVD drives connections from the motherboard. Place the RAM in
the other slot properly and then switch ON your computer.
If the problem still exists try resetting BIOS.
Turn off your PC and remove the power chord --> Open the cabinet --> Remove the CMOS battery for 15-30 minutes and then put it back properly. Now plug the power cord back in and switch ON your PC.
If the problem still exist, click on the below link and follow the instructions in "Hardware Reset".
https://ccm.net/faq/1192-lost-bios-password-resetting-the-bios
Good Luck.
0

Similar discussions

monitor keeps going in power save mode
diane31diane -
boog -

9 responses
LG monitor says D-sub no signal
Servant-Of-SSRR -
dinesh -

15 responses
Computer starts but monitor says "no signal"
smussery -
OMARJAWO -

2 responses
No signal going into power saving mode
Barb -
HelpiOS -

1 response
Monitor says No Input signal Need help!
Nutiler -
pcsces -

2 responses