Unable to format my sd card of 4gb
Closed
Abhishek
-
Updated by xpcman on 18/01/17 at 03:38 PM
KY_WD Posts 2053 Registration date Thursday October 23, 2014 Status Member Last seen February 28, 2017 - Jan 19, 2017 at 10:44 AM
KY_WD Posts 2053 Registration date Thursday October 23, 2014 Status Member Last seen February 28, 2017 - Jan 19, 2017 at 10:44 AM
Related:
- Unable to format my sd card of 4gb
- Network card - Guide
- Flash drive/card tester - Download - Backup and recovery
- Unable to ping computer on same network - Guide
- Format factory - Download - Other
- Tiktok unable to authorize twitter - TikTok Forum
1 response
KY_WD
Posts
2053
Registration date
Thursday October 23, 2014
Status
Member
Last seen
February 28, 2017
122
Jan 19, 2017 at 10:44 AM
Jan 19, 2017 at 10:44 AM
Hi there Abhishek,
How did you try to format your SD card? Can you share the steps? You have to know that you can format the USB flash through DISKPART, do you know that? :) If you still haven't tried it, here are the steps:
1. Open the Command prompt in administrator mode
2. Type DISKPART to enter the diskpart menu
3. Then type LIST DISK
4. After that type SELECT DISK X replacing the letter X with the number of disk which has been assigned by your PC. If you have one local disk which is disk 0, then the USB flash should be disk 1
5. Type SELECT DISK 1
6. When it gives the message that “disk 1 is now the selected disk” you have to type CLEAN – this will wipe out everything that you have in the pendrive
7. After that type FS=NTFS or FS=FAT32 depending on the size of files you would like to store
Let me know if that helped.
How did you try to format your SD card? Can you share the steps? You have to know that you can format the USB flash through DISKPART, do you know that? :) If you still haven't tried it, here are the steps:
1. Open the Command prompt in administrator mode
2. Type DISKPART to enter the diskpart menu
3. Then type LIST DISK
4. After that type SELECT DISK X replacing the letter X with the number of disk which has been assigned by your PC. If you have one local disk which is disk 0, then the USB flash should be disk 1
5. Type SELECT DISK 1
6. When it gives the message that “disk 1 is now the selected disk” you have to type CLEAN – this will wipe out everything that you have in the pendrive
7. After that type FS=NTFS or FS=FAT32 depending on the size of files you would like to store
Let me know if that helped.
