Folder copy from pendrive and micro sd card not
Closed
hari
-
Feb 19, 2016 at 02:30 AM
KY_WD Posts 2054 Registration date Thursday October 23, 2014 Status Member Last seen February 28, 2017 - Feb 19, 2016 at 11:01 AM
KY_WD Posts 2054 Registration date Thursday October 23, 2014 Status Member Last seen February 28, 2017 - Feb 19, 2016 at 11:01 AM
Related:
- Folder copy from pendrive and micro sd card not
- Network card - Guide
- Anvi folder locker reset key - Guide
- Pay netflix with debit card - Guide
- Sim card reader software - Download - Backup and recovery
- Pendrive not showing - Guide
1 reply
KY_WD
Posts
2054
Registration date
Thursday October 23, 2014
Status
Member
Last seen
February 28, 2017
122
Feb 19, 2016 at 11:01 AM
Feb 19, 2016 at 11:01 AM
Hello hari,
Are you logged in as an administrator to your PC? I ask you this because, the most probable reason you have been unable to access the external devices is that the peripheral slots have been restricted by an administrator. Please, make sure you are logged as the owner of the PC and not as a guest.
You could try the following commands while the USB device is connected:
1. Open command prompt
2. Type the following:
attrib -s -h -r X: /*.* / s / d Then hit "Enter" and wait about 30 seconds
Be careful! Respect the spaces between words and script. Change the letter X with that has been assigned to the USB device on your PC (that you can see it in My Computer. It can be anything, depends on each computer.)
3. Finally, browse the flash drive and delete the "RECYCLER" folder and if there is another one called "Autorun" you have to delete that too.
Let me know if that helped. Cheers.
Are you logged in as an administrator to your PC? I ask you this because, the most probable reason you have been unable to access the external devices is that the peripheral slots have been restricted by an administrator. Please, make sure you are logged as the owner of the PC and not as a guest.
You could try the following commands while the USB device is connected:
1. Open command prompt
2. Type the following:
attrib -s -h -r X: /*.* / s / d Then hit "Enter" and wait about 30 seconds
Be careful! Respect the spaces between words and script. Change the letter X with that has been assigned to the USB device on your PC (that you can see it in My Computer. It can be anything, depends on each computer.)
3. Finally, browse the flash drive and delete the "RECYCLER" folder and if there is another one called "Autorun" you have to delete that too.
Let me know if that helped. Cheers.
