The community to assist you!

Closed

Andrey - Jun 17, 2009 at 01:10 PM
andrey - Jun 17, 2009 at 01:26 PM

Hello, i got a Western Digital 500GB hard drive and it worked fine through USB but wet i connected it through SATA into the computer and boot it up it asks to enter some RAID options i enter that but still nothing i can do to make it work... so i tryed connecting it through usb and now it shows that the device was properly installed but its not showing on my computer only in device manegment........ please help... Thanx

The community to assist you!
Support assist download - Download - Cleaning and optimization
Review requested if we find that your posts or comments didn't follow our community standards, your account will remain disabled. we're always looking out for the security of people on facebook, so while your posts and comments are reviewed you can't use facebook. - Facebook Forum
Your comment goes against community standards ✓ - Facebook Forum
Slendytubbies 3 community edition download - Download - Horror
We're always looking out for the security of our community. because your identity can't be confirmed, you won't be able to request a review. ✓ - Facebook Forum

3 responses

Answer 1 / 3

jackoz Posts 6 Registration date Saturday March 28, 2009 Status Member Last seen June 18, 2009 3
Jun 17, 2009 at 01:11 PM

Hye when you connect by sata on your pc! You will have to change the SATA mode on your bios setting!!
Instead of IDE you will have to change it to SATA!

Answer 2 / 3

andrey
Jun 17, 2009 at 01:24 PM

i made it non RAID but still no HDD shown on my computer

Answer 3 / 3

andrey
Jun 17, 2009 at 01:26 PM

and i made the IDE to SATA still dont work

Similar discussions

Your comment goes against our Community Standards on spam

Confirm account Facebook

You have guessed the code too many times. Contact support

2 of your comments go against our standards on spam

Your post goes against our Community Standards

Similar discussions

Subscribe To Our Newsletter!