Previous Topic Next Topic

No signal to monitor at all!

Closed
Rachel - Aug 15, 2010 at 12:06 AM
 binod - Aug 15, 2010 at 05:48 AM
Hello,

I think i may have messed up my pc. My original problem was getting 2 monitors to work on one tower. I did all that i possibly could and had no luck, so i rebooted my pc and went into the system bios setting. Under primary video something i changed it from being AGP to Auto, saved changes then restart, after that my monitor went blank and now gets no signal. Help!



2 replies

Answer 1 / 2
Blocked Profile
Aug 15, 2010 at 04:55 AM
Hi there,

Reset the bios remove the battery on motherboard then after few minutes connect back,you should be getting the display or also remove the graphic card and clean it with alcohol or using a rubber eraser,

Thanks
0
Answer 2 / 2
binod
Aug 15, 2010 at 05:48 AM
first u make bios default settings,then reinstall multi pc driver
check wether ur vga is working or not,then restAart ur computer
if not fixen with this solution u may have problem on battery or ur board gone
0