Monitor gets no signal.
Closed
hawkrichard
-
21 Aug 2010 à 12:49
jack4rall Posts 6428 Registration date Sunday 6 June 2010 Status Moderator Last seen 16 July 2020 - 21 Aug 2010 à 21:36
jack4rall Posts 6428 Registration date Sunday 6 June 2010 Status Moderator Last seen 16 July 2020 - 21 Aug 2010 à 21:36
Related:
- Monitor gets no signal.
- Cru monitor - Download - Customization
- No signal on monitor but cpu running - Guide
- Sceptre monitor no signal entering power save mode - Windows Forum
- Portable monitor no signal power saving mode - Monitor Forum
- How to use tv as second monitor - Guide
1 response
jack4rall
Posts
6428
Registration date
Sunday 6 June 2010
Status
Moderator
Last seen
16 July 2020
21 Aug 2010 à 21:36
21 Aug 2010 à 21:36
Hello,
Try this 1.
If you failed to get the display even when your computer is Switched ON then
make sure that problem is not coming because of bad RAM or video card.
Remove the video card, connect your monitor to the onboard VGA and check
whether you are able to get the display or not.
Note : If you onboard VGA is disabled, then reset your BIOS.
Click on below link and try hardware reset.
https://ccm.net/faq/1192-lost-bios-password-resetting-the-bios
Remove the RAM from the slot, clean it and place it back properly or try another
slot. Even bad RAM will result you in display problem.
Also check your monitor and its VGA cable.
Good Luck.
Try this 1.
If you failed to get the display even when your computer is Switched ON then
make sure that problem is not coming because of bad RAM or video card.
Remove the video card, connect your monitor to the onboard VGA and check
whether you are able to get the display or not.
Note : If you onboard VGA is disabled, then reset your BIOS.
Click on below link and try hardware reset.
https://ccm.net/faq/1192-lost-bios-password-resetting-the-bios
Remove the RAM from the slot, clean it and place it back properly or try another
slot. Even bad RAM will result you in display problem.
Also check your monitor and its VGA cable.
Good Luck.
