The disk is write protected
Closed
sathish
-
Dec 29, 2014 at 04:52 PM
Ambucias
Ambucias
- Posts
- 47366
- Registration date
- Monday February 1, 2010
- Status
- Moderator
- Last seen
- September 1, 2021
Related:
- The disk is write protected
- The disk is write protected - Guide
- The disk is write protected usb format - Guide
- Kingston the disk is write protected ✓ - Forum - Hardware
- Moserbear 8gb pendrive is not Format The disk is write protected ✓ - Forum - Pen Drive/USB Key/SD Card
- Diskpart disk is write protected ✓ - Forum - Pen Drive/USB Key/SD Card
1 reply
Ambucias
Dec 29, 2014 at 05:36 PM
- Posts
- 47366
- Registration date
- Monday February 1, 2010
- Status
- Moderator
- Last seen
- September 1, 2021
Dec 29, 2014 at 05:36 PM
Click start
then run regedit
go to this directory HKEY_LOCAL_MACHINE\SYSTEM\Currentcontrolset\control\
if you can't find StorageDevicePolicies under control folder
then make some new one. Follow this steps:
step 1:
go to this directory HKEY_LOCAL_MACHINE\SYSTEM\Currentcontrolset\control\
again and right click control folder
step 2:
select new, then click key and rename the new key #1 folder into
StorageDevicePolicies
step 3:
right click StorageDevicePolicies folder and select new DWORD(32-bit) Value
for 32-bit Operating System and select new DWORD(64-bit) Value
for 64-bit Operating System
step 4:
rename dword newer folder into WriteProtect, then double click WriteProtect
and change the value data into 0 with hexadecimal base, Then close regedit
step 5:
open my computer and refresh it 5 times without do anything to your usb, and
properly eject your flash drive
step 6:
plug in your usb again into your computer and format it using exfat instead of fat32
then run regedit
go to this directory HKEY_LOCAL_MACHINE\SYSTEM\Currentcontrolset\control\
if you can't find StorageDevicePolicies under control folder
then make some new one. Follow this steps:
step 1:
go to this directory HKEY_LOCAL_MACHINE\SYSTEM\Currentcontrolset\control\
again and right click control folder
step 2:
select new, then click key and rename the new key #1 folder into
StorageDevicePolicies
step 3:
right click StorageDevicePolicies folder and select new DWORD(32-bit) Value
for 32-bit Operating System and select new DWORD(64-bit) Value
for 64-bit Operating System
step 4:
rename dword newer folder into WriteProtect, then double click WriteProtect
and change the value data into 0 with hexadecimal base, Then close regedit
step 5:
open my computer and refresh it 5 times without do anything to your usb, and
properly eject your flash drive
step 6:
plug in your usb again into your computer and format it using exfat instead of fat32