Drive light is on and power enters but the display screen black
Closed
ejoe
Posts
2
Registration date
Tuesday July 14, 2015
Status
Member
Last seen
July 14, 2015
-
Jul 14, 2015 at 03:52 AM
KY_WD Posts 2054 Registration date Thursday October 23, 2014 Status Member Last seen February 28, 2017 - Jul 15, 2015 at 10:41 AM
KY_WD Posts 2054 Registration date Thursday October 23, 2014 Status Member Last seen February 28, 2017 - Jul 15, 2015 at 10:41 AM
Related:
- Drive light is on and power enters but the display screen black
- Acer laptop blue light on but screen is black - Laptop Forum
- Monitor power light blinking but no display reasons ✓ - Hardware Forum
- 3 beeps on startup no display ✓ - CPU & Desktop Forum
- No display on monitor but cpu running ✓ - Hardware Forum
- Acer laptop wont start up ! ✓ - Laptop Forum
1 reply
KY_WD
Posts
2054
Registration date
Thursday October 23, 2014
Status
Member
Last seen
February 28, 2017
121
Jul 15, 2015 at 10:41 AM
Jul 15, 2015 at 10:41 AM
Hi ejoe,
The problem that you have might be due to the failure of the video chip. Sometimes, after much of a use and less cooling the so called North Bridge, which is responsible for video signal transmission get unsolders, the thermic paste is gone, therefore the screen doesn't show anything. If you possess knowledge of notebooks' hardware you can change the paste yourself by opening the laptop and check if the chipset that is next to the processor has got unsoldered or you can bring your laptop to a technician to get it soldered again.
Hope this helps.
KY_WD
The problem that you have might be due to the failure of the video chip. Sometimes, after much of a use and less cooling the so called North Bridge, which is responsible for video signal transmission get unsolders, the thermic paste is gone, therefore the screen doesn't show anything. If you possess knowledge of notebooks' hardware you can change the paste yourself by opening the laptop and check if the chipset that is next to the processor has got unsoldered or you can bring your laptop to a technician to get it soldered again.
Hope this helps.
KY_WD