Previous Topic Next Topic

Monitor no signal

Closed
ryan - May 28, 2016 at 07:33 AM
xpcman Posts 19530 Registration date Wednesday October 8, 2008 Status Contributor Last seen June 15, 2019 - May 28, 2016 at 08:33 PM
Hi all issue I am having is we had a power outage and after then my displays have no signal, I did a HEAP of research and found that if I disconnect the cmos battery for a few min and refit should be ok, I did that and it worked BUT now every time I restart my pc again no displays unless I open it up and repeat the process of remove battery and refit then it works.

any help on so I don't need to do this every time would be amazing.

My pc is a
Alienware x51 r1,
i7 3770 ivy bridge
8 gb ram
gtx 660
1tb hhd.

1 response

Answer 1 / 1
xpcman Posts 19530 Registration date Wednesday October 8, 2008 Status Contributor Last seen June 15, 2019 1,826
May 28, 2016 at 11:54 AM
I suggest you buy a new CMOS battery.
0
Ryan
May 28, 2016 at 08:26 PM
I'll be buying one, I have never noticed slow time or more common issues with low/dead battery just this having to disconnect and refit issue
0
xpcman Posts 19530 Registration date Wednesday October 8, 2008 Status Contributor Last seen June 15, 2019 1,826 > Ryan
May 28, 2016 at 08:33 PM
A new battery may not fix the problem. But, it will Allow a better chance for the BIOS to boot.

Good luck
0

Similar discussions

LG monitor says D-sub no signal
Servant-Of-SSRR -
dinesh -

15 responses
monitor keeps going in power save mode
diane31diane -
boog -

9 responses
LG monitor it keeps saying D- Sub, power saving mode
Joshua Conley -
Raif -

5 responses
Monitor: No signal 'Entering power saving mode shortly'
noor1365 -
KY_WD -

1 response
Computer starts but monitor says "no signal"
smussery -
OMARJAWO -

2 responses